Author Topic: T35 worn fork link surface  (Read 882 times)

0 Members and 1 Guest are viewing this topic.

Offline douglas1947

  • Master Member
  • ****
  • Join Date: Feb 2014
  • Posts: 518
  • Location: Germany
T35 worn fork link surface
« on: 15 Feb 2021 at 16:17 »
On my t35 are the fork link surfaces are worn.
I have tried to "seal" the  oil seal with water pump grease, but with no total success.
I have read in the forum of a repair with glueing a shim to the worn link surface, but I can not find the informations with the detail. I remember Eddie has written it??

Who can give me please an advise?


Offline Doug

  • Administrator
  • ****
  • Join Date: Mar 2004
  • Posts: 4629
  • Location: Glen Mills, PA, USA

Offline tck

  • Senior Member
  • ***
  • Join Date: Jul 2004
  • Posts: 382
    • old racer
Re: T35 worn fork link surface
« Reply #2 on: 16 Feb 2021 at 10:10 »
After reading up via the search engine (always the best first action) I bought some shim stock cut it up with scissors and araldited it in position I was also minded to try some modern 'edge seals' but did not  think the ones I bought were any improvement  on the O rings. the proof of the pudding will be in the eating.