Author Topic: Dragonfly induction pipes  (Read 229 times)

0 Members and 1 Guest are viewing this topic.

Offline Sgtbiro

  • Senior Member
  • ***
  • Join Date: Oct 2017
  • Posts: 160
  • Location: Newcastle upon Tyne
Dragonfly induction pipes
« on: 15 Feb 2021 at 19:14 »
Hi all help needed. i have just received my induction pipes back from the rechromers  and i think they have taken to much off the diameters of the pipes while polishing them as they are now a lose fit in the glands i have put new seals in the glands that i bought from the LDMCC. is there a work around or will i have to obtain some new pipes from somewhere.

Cheers Kevin..

 

Offline eddie

  • Master Member
  • ****
  • Join Date: Mar 2006
  • Posts: 1679
  • Location: Hampshire, UK
Re: Dragonfly induction pipes
« Reply #1 on: 15 Feb 2021 at 19:39 »
Kevin,
          The 'O' rings supplied by the LDMCC would have been to an imperial size with a 1" bore - have a look at Simply Bearings website, there may be a metric 'O' ring with a 25mm bore that is slightly larger in section. Fitting the larger section ring into the end fittings shouldn't be a problem, as 'O' ring grooves are usually wide enough to allow the ring to float.

   Regards,
                  Eddie.