Author Topic: EW gearbox adjuster  (Read 2682 times)

0 Members and 1 Guest are viewing this topic.

Offline oily bloke

  • Senior Member
  • ***
  • Join Date: Mar 2009
  • Posts: 220
  • Location: Surrey. UK
EW gearbox adjuster
« on: 26 Feb 2014 at 06:29 »
Hi all,
Looking for some advice on the adjuster that pulls the gearbox back to adjust the primary chain on an EW350.
The one I copied off of a mates un-restored bike appeared to be one piece. The threaded hole on the gearbox is blind and not all that deep.
Is the adjuster one piece or should it thread into itself as well as the box?
It seems to me that the level of adjustment is less than I would expect.
Thanks
Andy

Offline Jim

  • Full Member
  • **
  • Join Date: Mar 2011
  • Posts: 32
  • Location: Victoria, Australia
Re: EW gearbox adjuster
« Reply #1 on: 26 Feb 2014 at 23:21 »
Andy, it should be two pieces, a 3/8 BSF stud and a shaped nut that does the work, I can give dimensions if you want them, regards Jim

Offline oily bloke

  • Senior Member
  • ***
  • Join Date: Mar 2009
  • Posts: 220
  • Location: Surrey. UK
Re: EW gearbox adjuster
« Reply #2 on: 27 Feb 2014 at 06:19 »
Thanks Jim,
I thought it must have been 2 parts. I have the dimensions I need.
Thanks again
Andy