Hi to everybody.
Time ago (6 month) i bought a douglas, well.. a mixture of somethings, then i discover what is a douglas, and i fall in love with it, the bike was so bad that it will be difficult to restore, but i will (with a lot of time). When I started to search pieces, i discover that it will be really expensive, and i can not afford it, so i start designing (with my small knowledge of computing) a DT engine, in solidworks just to enjoy.
I get most of the photos from this forum, but after a few work (i have something done) i have so many doubts that i would like to solve.
So after this introduction, i would like to know if i could get some replies, about how the oil works in lump sump engines, like this one:
And how works the RA oil deposit.
I will try to prepare tomorrow some photos to extend the information about what i am doubting.
Till then may i have some information?.
Kind regards
