Hi all,
I´m just finishing my H3 project but have a problem with the clutch.
I have fitted the flywheel/clutch after regrinding the overhault crank cone with the old clutch plate (was 3,3mm lining, so not so much left).
The clutch had no good contact to the backplate, because there was not enough space at the bearing of the operating lever. So I dicided to renew the lining with new 5mm lining. Unfortunately this 1.7mm thicker lining was not enough to get more space at the operating bearing. I will need a small space to get the bearing disengaged to a nd full pressure of the lining to the back plate.
Has anyone an idea for help?
Michael