ew350 flywheel extractor

[Neilj]

Anyone in Newport or bristol got a flywheel extractor i could borrow. Could bring my engine around and do it there and then if that would be ok.Bit cheeky i know. 
 

[jimf]

Has the club any for sale.and how much

[Neilj]

Might be usefull info.held the engine minus head and pistons just off the bench nice and horizontal by the flywheel while my son took a aluminiam dowl 30mm and gave the crank one decent tap.The engine droped straight onto my rag pile no problem.Just one sharp metal to metal tap,metal hammer used as well.

[tck]

I made the most massive extractor to no avail (see New Con Rod and on this forum )in the end a small extractor did the job, the secret? lots and lots of heat

[Daren W Australia]

Hi
I had to remove 4 last week 3 others basically fell of with a sharp tap the fourth I used this set up i tightened it to 3 dugga dugga on my cheap rattle gun came ack an hour latter and gave it a sharp blow with a lump hammer.
Ta Daren





Image orientation fixed and converted to linked files - Dave, 02Aug2021

[Neilj]

Loving the technical 3 Duggar Duggar.Do us a favour can you measure the thickness of ring on the flywheel that mates with the clutch release/thrust bearing.Im making one got the inside and outside by measuring,but can only guess the thickness from photo,s like yours.Cheers Neil

[Daren W Australia]

Hi Neil I get 190 thou but its pretty crusty also it will depend on your taper and how many times its been lapped ta Daren







Images converted to linked files - Dave,14Aug2021

[Neilj]

Thanks it’s the ring on the flywheel side the one the balls rub up against is the one I need the width please.thanks Neil