« previous next »
Pages: 1

Author Topic: Mark V swing arm pivot pin end cap  (Read 2592 times)

0 Members and 1 Guest are viewing this topic.

Offline steveL

  • Full Member
  • **
  • Join Date: Feb 2011
  • Posts: 40
  • Location: Sutton Coldfield, West Midlands, UK
Mark V swing arm pivot pin end cap
« on: 18 Dec 2016 at 14:47 »
Hi Douglas aficionado's

Can anybody tell me the size of the bolt which screws into the ends of the pivot pins on the swing arm. It looks like they keep the grease in (I think).

Any help greatly appreciated.

Steve.
Logged

Offline steveL

  • Full Member
  • **
  • Join Date: Feb 2011
  • Posts: 40
  • Location: Sutton Coldfield, West Midlands, UK
Re: Mark V swing arm pivot pin end cap
« Reply #1 on: 19 Dec 2016 at 18:15 »
Ive found out (by trial and error), that its the same size as the bolt securing the anchorage plate to fork on the rear brake drum assembly - which from the parts list is 1/2" BSF.

Hope this helps someone in the future.

Steve.
Logged

Offline douglas1947

  • Master Member
  • ****
  • Join Date: Feb 2014
  • Posts: 518
  • Location: Germany
Re: Mark V swing arm pivot pin end cap
« Reply #2 on: 20 Dec 2016 at 16:51 »
Yes, it is a short bolt hexagon head 1/2" BSF and only 1/2" long thread; in the center a grease nipple.

Do you need a photo?

Michael
Logged

Offline steveL

  • Full Member
  • **
  • Join Date: Feb 2011
  • Posts: 40
  • Location: Sutton Coldfield, West Midlands, UK
Re: Mark V swing arm pivot pin end cap
« Reply #3 on: 21 Dec 2016 at 06:51 »
Hi Michael,

No, don't worry, but really useful to understand the length, and confirmation of the size. I can see from the parts catalogue that it has a grease nipple in it.

Many thanks for taking the time to clarify.

Steve.
Logged
Pages: 1
« previous next »