« previous next »
Pages: 1

Author Topic: Mk5 clutch actuation  (Read 3923 times)

0 Members and 1 Guest are viewing this topic.

Offline dalgrae

  • Full Member
  • **
  • Join Date: Jun 2014
  • Posts: 138
  • Location: bristolEXMUR
Mk5 clutch actuation
« on: 06 Nov 2019 at 11:44 »
Hi I need the 3 small hardened rollers that are on the clutch actuation mechanism for my Mk5 ref plate 14 ,can I use silver steel suitably machined and then hardened and tempered.

Any advice most welcome

Colin
Logged

Offline phil1

  • Full Member
  • **
  • Join Date: Mar 2017
  • Posts: 75
  • Location: Aylesbury
Re: Mk5 clutch actuation
« Reply #1 on: 06 Nov 2019 at 13:40 »
Hi Colin have had my MkV stripped to the last nut and bolt and I would do as you say, use silver steel to re make those rollers part no 11222, if you have the dimensions ? I could help if needed. Cheers Phil.
Logged

Offline dalgrae

  • Full Member
  • **
  • Join Date: Jun 2014
  • Posts: 138
  • Location: bristolEXMUR
Re: Mk5 clutch actuation
« Reply #2 on: 06 Nov 2019 at 14:11 »
Hi thanks for the reply and the offer,I have some existing rollers but with lots of wear on the bores so I am Ok for the sizes it was the material I needed advice on

Regards. Colin
Logged

Offline robertolander

  • Member
  • *
  • Join Date: Oct 2008
  • Posts: 12
Re: Mk5 clutch actuation
« Reply #3 on: 17 Nov 2019 at 14:55 »
Colin: If you can locate a piece of chain that has the inside of the rollers at 6mm these will do wonderfylly! regards Jumbo
Logged

Offline douglas1947

  • Master Member
  • ****
  • Join Date: Feb 2014
  • Posts: 518
  • Location: Germany
Re: Mk5 clutch actuation
« Reply #4 on: 17 Nov 2019 at 16:08 »
Colin,

I used the rollers of a 3/8 x 1/4" chain for replacing these rollers.

Michael
Logged
Pages: 1
« previous next »